Rhino AP-GSM

Rhino AP-GSM

Rhino AP is an IoT gateway designed to read data from metering devices and sensors. It is equipped with multiple communication interfaces supporting most popular protocols. In addition, it includes two RF channels for wireless communication with Rhino hardware. This allows Rhino devices to be configured and customised to implement an Advance Metering Infrastructure (AMI) class smart metering system in the building. The collected data is sent to the Rhino Cloud Platform via Ethernet or GSM (SIM card pre-installed). Rhino AP-ETH is powered by external 5-24DC power supply.




Technical parameters

Communication type Ethernet (DHCP / Static IP address) or GSM (LTE / GPRS / WCDMA / HSPA)
Rhino communication Frequency range: 433MHz
ISM channel 1 – Rhino ED DI / ED DI-D / Sensors
ISM channel 2 – Rhino ED RS485 / RS232Maximum of 50 end devices on each radio channel
Input voltage 5-24VDC (> 10W)
Internal battery 2700 mAh (emergency power supply)
Internal memory uSD card (min. 8 GB)
Logging of measurement data Yes
Interface protocols RS232 – DLMS, IEC62065
RS485 – DLMS, IEC62065, Modbus RTU, Gazmodern I, Gazmodern II
Ethernet – DLMS, IEC62065, BACnet, Modbus TCP/IP, Custom network protocols
Optional interfaces – M-Bus, Wireless M-bus OMS
Configuration Over the Air (OTA)
Firmware update Over the Air (OTA)
Operating temperature 0 ℃ – 85 ℃ (depending upon installed temperature)
IP class IP40 (not suitable for outdoor use)
Dimensions 87.5 mm x 90.0 mm x 65.0 mm (5 DIN modules)
Weight -0.2kg
Additional equipment 1 x ISM antenna with 3m cable and magnetic base
1x GSM antenna with 3m cable and magnetic base (included)